Furuno FMD-3005 Installation Manual page 88

APPX. 4 ALERT LIST
Alert No.
ALF ID ALR ID
3015,22 272
3015,23 277
3015,24 279
3015,25 284
3015,26 450
3015,27 453
3015,28 278
3015,30 380
3016,24 382
3016,25 383
AP-16
Alert Name, Meaning and Remedy
Name: Lost UTC Signal
Meaning: Time data of all available GPS sensor has been
not available for more than 3 seconds.
Remedy: Check position sensor, sensor status.
Name: Lost Wind Signal
Meaning: Wind speed/direction data of all available WIND
sensors has been not available for more than 3 seconds.
Remedy: Check the connection with all wind sensors. Al-
so, check sensor status.
Name: Lost COG/SOG SIG
Meaning: COG/SOG data input stopped for three sec-
onds.
Remedy: Check the connection with all GPS sensors. Al-
so, check sensor status.
Name: Lost LOG(BT) SIG
Meaning: SOG data of all available LOG (ground speed)
sensors has been not available for more than 3 seconds.
Remedy: Check the connection with all LOG sensors. Al-
so, check sensor status.
Name: Lost Heading SIG
Meaning: Heading data of all available gyro has been not
available for more than 2 seconds.
Remedy: Check the connection with all gyro. Also, check
sensor status.
Name: Lost SDME Signal
Meaning: Speed data from all available SDME has been
not available for more than 3 seconds.
Remedy: Check the connection with all SDME. Also,
check sensor status.
Name: Lost LOG(WT) SIG
Meaning: STW data of all available SDME sensors has
been not available for more than 3 seconds.
Remedy: Check the connection with all SDME. Also,
check sensor status.
Name: Lost AIS COM
Meaning: Data from AIS has been discontinued for more
than set time. (Set at installation)
Default: 60 seconds
AIS is turned off, or there is a problem with network.
Remedy: Check the connection with AIS and network.
Name: Lost COG/SOG SIG
Meaning: COG/SOG data input stopped for three sec-
onds.
Remedy: Check the connection with all GPS sensors. Al-
so, check sensor status.
Name: Lost LOG(BT) SIG
Meaning: SOG data of all available LOG (ground speed)
sensors has been not available for more than 3 seconds.
Remedy: Check that connection with all LOG sensors. Al-
so, check sensor status.
Priority/
Category
Warning/B
Warning/B
Warning/B
Warning/B
Warning/B
Warning/B
Warning/B
Warning/B
Caution/B
Caution/B