Table of Contents
Advertisement
1.2.2
Flush mounting
Use the optional flush mount kit to mount the control unit in a console panel.
Control Unit
RCU-024
RCU-026
1. Prepare a cutout in the mounting location as shown on below.
RCU-024
2. Set the control unit to the cutout.
3. Attach the mounting plate to the control unit with four screws from the rear side.
4. Screw the wing screw to each mounting plate and then insert hex. bolt to each
wing screw.
5. Fasten each wing screw and then fasten the wing nuts as shown in figure below.
RCU-026
Flush mount kits for RCU-024/025
Type
OP24-24
OP24-27
Outline of unit
398
388±2
Side view of control units
Code No.
001-171-790
001-171-820
180
170±2
RCU-026
RCU-024
1. MOUNTING
Outline of unit
1-3
Advertisement
Table of Contents
