Furuno FMD-3005 Installation Manual page 27

Connection
1. Unfasten four screws (M4x8) to remove the top cover from the processor unit.
2. Unfasten three bolts shown below to remove the upper plate of the cable clamp.
J4 J4
J8 J8 J6 J6
J12 J12 J13
J11 J11
J9 J9
J5 J5 J3 J3
J7 J7
J10 J10
Unfasten this bolt to use Unfasten this bolt to use
the lower clamp holes. the lower clamp holes.
Unfasten these three bolts to remove the upper plate.
3. Pass the cables through the clamp holes, then fasten the bolts removed at step 2
to fix the cables.
4. Connect the WAGO connectors appropriately to the I/O Board, referring to the in-
terconnection diagram.
J3 to J6: IEC 61162-1/2
J7 to J10: IEC 61162-1
J13
J11: Alarm system (System fail, Power fail,
J14 J14
J12: Main control unit
J13 and J14: Sub control units
Processor unit, top view
Normal close×2, Normal open×2, ACK IN)
Clamp holes (upper)
Clamp holes (lower)
Lay shields of cables
under this clamp then
tighten the clamp.
2. WIRING
2-7