Furuno FMD-3005 Installation Manual page 43

Connection
J2 J2
J1 J1
Note: Fasten the cable shield with the cable clamp.
Input method (MC-3010A only)
Select the method of the analog data input, power voltage or power current.
Note 1: The input must not exceed the range of the input voltage, to prevent malfunc-
tion.
-Setting for voltage input: -10V to +10V or 0 to 10V (depending on the setting)
-Setting for contact input: Voltage 4mA to 20mA.
Note 2: When changing the input method, turn off the MC-3010A and on again to put
change in effect.
For TTYCSLA cables, pass the drain wire
through the shrink tube, then attach these crimp-
on lugs and screws to connect drain wires to here.
J5 J5
J4 J4
J3 J3
TTYCS-1/ TTYCS-1/
TTYCSLA-1 TTYCSLA-1
MC1.5-W-L cable MC1.5-W-L cable
MC-3010A
J6 J6
J4 J4
J5 J5
J2 J2
J3 J3
J1 J1
MPYC-12 MPYC-12
MC1.5-W-L cable MC1.5-W-L cable
MC-3020D/3030D
IV-1.25sq. (Local supply) IV-1.25sq. (Local supply)
IV-1.25sq. (Local supply) IV-1.25sq. (Local supply)
2. WIRING
2-23