Table of Contents
Advertisement
SYSTEM CONFIGURATION
: Standard
: Option
: User Supply
Contact Signal IN
Contact Signal OUT
PC (for serviceman)
Heading Sensor
External Buzzer
NAV Equipment
(NMEA 0183)
CAN bus Equipment
(NMEA 2000)
EVC System*
*
1
: Attach the terminator (type: BD-07AFFM-LR7001) to the port not used on the last control unit
in the series.
2
*
: Not required for Fantum Feedback
*
3
: Not required for a EVC system equipped vessel.
*
4
: Connect one Dial-type Remote Controller FAP-5551 to one Distributor FAP-6800.
*
5
: EVC systems compatible with the NAVpilot are as follows:
EVC System
VOLVO PENTA IPS
YAMAHA Helm Master
YANMAR VC10
SEASTAR SOLUTIONS
OPTIMUS
x
Control Unit
FAP-7011C
PG-700
Processor Unit
FAP-7002
Event Switch
5
12-24 VDC
TM
([Rudder Sensor] = [Fantum Feedback]).
Requires VOLVO interface kit FAP-6300 (available as an optional extra).
Requires YAMAHA HM interface kit FAP-6310 (available as an optional extra).
• Connect through the NMEA data converter IF-NMEA2K2 (ver.01.07 or later).
• Requires connector assembly AT06-2S-EC01-VCT-030 (available as an optional extra).
• Connect through the NMEA data converter IF-NMEA2K2 (ver.01.16 or later).
• The software version of the connected Main PCM (Pump Control Module) must be "Rev. T" or
later.
Control Unit
FAP-7001
Control Unit Qty: Max. 6*
The processor unit has two connection
lines for the control unit.
Three control units can be connected
per each connection line.
Solenoid
Valve
Hydraulic Linear Drive
Rudder Reference Unit
FAP-6112*
Remote Controller
Distributor FAP-6800
Remote Controller:
Dial Type: FAP-5551*
Lever Type: FAP-6221, FAP-6222
Dodge Type: FAP-6231, FAP-6232
Remarks
1
Ship's
Steering
3
System*
2
4
, FAP-5552
Advertisement
Table of Contents
