Furuno FMD-3005 Installation Manual page 5

System with two processor units
Monitor Unit
*1
(Main Monitor)
ECDIS
Control Unit
RCU-024
or
Trackball
Control Unit
RCU-026
ECDIS
Control Unit
RCU-024
or
Trackball
Control Unit
RCU-026
(Max. 2)
IF Signal:
- Serial Interface ×4
(IEC 61162-1/2)
- Serial Interface ×4
(IEC 61162-1)
- Digital Out ×6
(power fail/system fail/
NO ×2, NC ×2)
- Digital In (ack in)
Category of units
220-230 VAC,
All units protected
1ø, 50/60 Hz
from the weather.
Dashed lines indicate
optional or local supply
equipment.
*1
: For the monitors available for connection with the ECDIS, see page iv.
*2: When the network complies with IEC 61162-450 Ed.1, the Switching Hub HUB-100 can also
be used. (FMD-3200/3200-BB/3300 only)
Note: When using the EC-3000/3005 as an AMS device, connect an emergency power supply, in
addition to the main power supply.
Monitor Unit Monitor Unit
*1
(Sub Monitor) (Conning Monitor)
Gateway network
(radar, ECDIS, etc.)
PROCESSOR
UNIT
EC-3000
(FMD-3200/
3200-BB/3300)
OR
Radar Connection Box
EC-3005
( MD-3005)
24 VDC
100-115/
Sensor Adapter Sensor Adapter
MC-3000S MC-3010A
Serial
interface interface
Monitor Unit
*1 *1
(Main Monitor)
equipment
PROCESSOR
Intelligent HUB
HUB-3000
(FMD-3200/
3200-BB/3300)
100-230 VAC
RCB-002
( MD-3005)
Radar 1
Radar 2
AC/DC Power
Supply Unit
PR-240/241
100-115/200-230 VAC
1ø, 50/60 Hz
Intelligent HUB
*2
HUB-3000
Sensor Adapter
MC-3020D
Analog Digital IN
interface
SYSTEM CONFIGURATION
Monitor Unit Monitor Unit
*1 *1
(Sub Monitor) (Conning Monitor)
ECDIS
Control Unit
RCU-024
or
Trackball
Control Unit
RCU-026
ECDIS
UNIT
Control Unit
EC-3000
RCU-024
or
Trackball
Control Unit
OR
RCU-026
(Max. 2)
EC-3005
IF Signal:
(Same as left.)
100-115/
220-230 VAC,
1ø, 50/60 Hz
Sensor Adapter
MC-3030D
Digital OUT
interface
iii