Moving The Xstation - IBM XStation 130 Set Up And Operation Manual

.
~,
Moving the Xstation
There are safety precautions that must be taken when the Xstation is moved. If you want a
trained person to move your Xstation, contact your IBM sales or service representative. If
you decide to move the unit yourself, take the following precautions:
DANGER
AN ELECTRICAL OUTLET THAT IS NOT CORRECTLY WIRED COULD PLACE
HAZARDOUS VOLTAGE ON METAL PARTS OF THE SYSTEM OR THE
DEVICES THAT ATTACH TO THE SYSTEM. IT IS THE RESPONSIBILITY OF
THE CUSTOMER TO ENSURE THAT THE OUTLET IS CORRECTLY WIRED AND
GROUNDED TO PREVENT AN ELECTRICAL SHOCK.
BEFORE INSTALLING OR REMOVING SIGNAL CABLES, ENSURE THAT THE
POWER CABLES FOR THE SYSTEM UNIT AND ALL ATTACHED DEVICES ARE
UNPLUGGED.
WHEN ADDING OR REMOVING ANY ADDITIONAL DEVICES TO OR FROM THE
SYSTEM, ENSURE THAT THE POWER CABLES FOR THOSE DEVICES ARE
UNPLUGGED BEFORE THE SIGNAL CABLES ARE CONNECTED. IF POSSIBLE,
DISCONNECT ALL POWER CABLES FROM THE EXISTING SYSTEM BEFORE YOU
ADD A DEVICE.
USE ONE HAND, WHEN POSSIBLE, TO CONNECT OR DISCONNECT SIGNAL
CABLES TO PREVENT A POSSIBLE SHOCK FROM TOUCHING TWO SURFACES
WITH DIFFERENT ELECTRICAL POTENTIALS.
DURING AN ELECTRICAL STORM, DO NOT CONNECT CABLES FOR DISPLAY
STATIONS, PRINTERS, TELEPHONES, OR STATION PROTECTORS FOR
COMMUNICATIONS LINES.
DANGER
TO PREVENT SHOCK HAZARD, DISCONNECT THE POWER CABLE FROM
THE ELECTRICAL OUTLET BEFORE RELOCATING THE SYSTEM.
CAUTION:
This product is equipped with a three-wire power cable and plug for the user's safety.
Use this power cable in conjunction with a properly grounded electrical outlet to
avoid electrical shock.
1. If you are logged on to a host system, log off the attached network (Hold down the Ctrl
and Alt keys and then press the Backspace key).
2. Turn off the Xstation system unit, display, and all attached separately-powered devices.
3. Unplug the Xstation system unit, display, and all attached separately-powered devices
from power outlets.
4. Be sure to label all of the cables as you disconnect them.
5. Check all of the electrical power outlets in the location to which you are moving for
correct wiring, voltage, and grounding before attaching the Xstation system unit, display,
or separately-powered devices.
6. Connect all signal cables to the display and system unit before plugging any power
cables into electrical outlets.
Operating the Xstation
2-19