IBM XStation 130 Set Up And Operation Manual page 32

Step 8. Configure Ethernet
The Xstation contains two Ethernet versions which differ by the external cable connector.
The factory-set, "thin" version uses a co-axial connector; the alternate, "thick" version uses a
15-pin D Shell connector. If you elect to use the alternate version, you must change the
jumpers (JP2) on the system board.
Do you want to configure Ethernet?
No Go to "Step 9. Configure System Jumpers" on page 1-16.
Yes
After completing "Step 4. Remove the Chassis Assembly" on page 1-6,
perform the following steps:
Ethernet
Thick
Ethernet
Thin
1. Turn the chassis so that the power switch faces you.
2. Locate the Ethernet jumpers (JP2) on the system board.
3. Change all of the individual jumpers (7) to either the thin or thick setting as shown:
CONTINUE
1-14
Setup and Operator Guide