IBM XStation 130 Set Up And Operation Manual page 35

Step 1 O. Install an Optional Disk Drive
Do you want to install an optional disk drive?
No Go to "Step11. Replace the Chassis Assembly" on page 1-18.
Yes
After completing "Step 4. Remove the Chassis Assembly" on page 1-6,
perform the following steps:
1. Turn the chassis so that the power switch faces you.
2. To install the optional disk drive:
a. Place the disk drive on its bracket and slide it toward the back of the Xstation until the
release tab snaps into place.
b. Connect one end of the disk drive cable to the connector located on the back of the
disk drive.
c. Connect the other end of the disk drive cable to the top of the riser card assembly.
Disk Drive
Mounting
Bracket
Disk Drive
Cable
Riser Card
Connector
Rele:eT8b\
Disk Drive
3. Go to "Step11. Replace the Chassis Assembly" on page 1-18.
Setup
1-17