Table of Contents
Advertisement
1. Turn the Xstation power off.
2. After referring to the I/O panel diagram below, connect the following cables to the
Xstation in order, if not already connected.
a. The keyboard and any other input devices.
b. Network cables. The ethernet (thick) cable input version requires a user-supplied
standard D-Shell connector. The co-axial (thin) cable input version of ethernet
requires a user-supplied, BNe-style coaxial "T" connector. To prevent signal
weakening or loss, the stub length of the connector, that is, the portion extending
from the I/O panel to the cable, should be a maximum of 1 inch.
I
4
I/O Panel
Stub Length - 1" max.
!
/
Ethernet BNC Coaxial "T" Connector
c. Serial or parallel devices.
d. The display signal cable. Use of the IBM 6091 display requires that an FCC-eertified
signal cable such as IBM part number 58F2901 or equivalent be used.
e. The power cable.
Optional Adapter Connector
Token Ring Adapter
I
<;;j
Dual Async Adapter
S4R
><
;:JS3,
~
/
\
/
/
Mouse
Parallel Connector
Keyboard
Power Plug
Display Signal
Connector
o
I/O Panel
Ethernet Connectors
Thick
Thin
3. Plug the display and Xstation system unit power cables into electrical power receptacles.
4. Continue to "Starting the Xstation" on page 2-2.
1-22
Setup and Operator Guide
Advertisement
Table of Contents
