IBM XStation 130 Set Up And Operation Manual page 24

Step 4. Remove the Chassis Assembly
1. Unlock and remove the customer security Rrotection device, if installed.
2. Set the Xstation system unit, display, and attached device power switches to Off (0).
Power Indicator
I
o
o
Power Switch
3. Unplug the system unit power cable, display power cable, and attached device power
cables from electrical power outlets.
4. Press down on each end of the plastic tab that extends from the upper edge of the rear
cover. When the latches disengage, pull on the plastic tab, and slide out the chassis and
power supply as a single unit. Remove any cable attached to the I/O panel that restricts
movement as the chassis assembly is extended.
5. With one hand, touch any metal surface of the chassis to minimize static electrical
charges before handling any internal component.
Tab
6. Go to "Step 5. Install a Token-Ring or Dual Async Adapter" on page
1-7.
1·6
Setup and Operator Guide