Network Setup - IBM XStation 130 Set Up And Operation Manual

Network Setup
Pressing F12 while the LAN Statistics Screen is displayed should display the Network Setup
menu, which allows you to select your primary network (Token-Ring, Ethernet, or SLIP).
This menu also sets up the SLIP communication parameters. Press F1 on the selected
option for help information.
Network Setup Page 1
Primary Network
Token ring
Enable SLIP YES
Serial Port SERIAL 1
Baud Rate
9600
Terminal Internet Address
Host Internet Address
Subnet Mask
Dial String
Disable Bootp No
TFTP File Name
Tag Field
Esc
=
Quit F1
=
Help F12
=
Save Page Down
Uset or
-t
to move the highlighted bar
Use'- or -. to change selection
Pressing Page Down while Network Setup page 1 is displayed will display Network Setup
page 2. This screen allows the user to configure the Ethernet port for special cases such as
booting through Gateways and booting without the use of the Bootp protocol. Modifications
to this menu are not necessary for normal operation. Press F1 on the selected option for
help information.
Network Setup
Page 2
Ethernet/IEEE 802.3
Automatic
Gateway Internet Address 192.35.17.3
Terminal Internet Address
192.35.17.2
Host Internet Address 192.35.17.1
Disable Bootp
No
TFTP File Name
Tag Field
Esc
=
Quit F1
=
Help F12
=
Save Page Down
Use
t
or
-t
to move the highlighted bar
Use'- or -. to change selection
CONTINUE
2-16
Setup and Operator Guide