IBM XStation 130 Set Up And Operation Manual page 43

'"',
When the POST has successfully completed (one audio beep), the LAN Statistics Screen
should display information for applicable LANs.
If the Xstation fails to complete the POST or LAN communications, go to "Problem
Determination Procedures (POPs) "on page 3-2.
Notes:
1. Ensure that you report the ethernet and token-ring hardware addresses displayed
on the LAN Statistics Screen to your system or network administrator so they can
configure the Xstation on the network.
2. When multiple networks are installed and one of the LANs is inoperative due to
network or Xstation problems, the program will be loaded from the operative LAN
if your Xstation is configured on a host on that LAN. If all LANs are inoperative, the
"not OK" screen will be displayed. Refer to "Problem Determination Procedures
(POPs) "on page 3-2.
3. Token-ring data will appear only if the Token-Ring Adapter is installed.
4. SLIP terminal information will appear if SLIP has been enabled.
If the LAN error code field for the host network is 0000, the Xstation program is executing;
your particular login window will appear next. If an error code is received, or the login
window fails to appear within four minutes, go to "Problem Determination Procedures
(POPs) "on page 3-2.
CONTINUE
Operating the Xstation
2·3