IBM XStation 130 Set Up And Operation Manual page 26

3. Remove the shoulder stud from the system board.
4. Insert the adapter so that the sheet metal bracket is seated between the chassis guide
rails.
5. Place the slotted end of the adapter sheet metal bracket behind the thin sheet metal tab
receptacle on the chassis.
6. The extender portion of the adapter should be resting on the first and second tabs on the
chassis front.
7. Grasp the long edge of the adapter (opposite the contact tab) with your fingers iand, with
your thumb on the back of the riser card assembly, firmly squeeze the adapter into the
connector.
8. The contact tab of the adapter should be approximately three millimeters (one-eighth of
an inch) from entering the riser connector.
Extender Portion
of Adapter
.~
Riser Card Assembly
Thin Sheet Metal Tab
' - _ - - Slotted End of Sheet Metal
Bracket
'-;':---~lft---
_ _
Contact Tab
First and Second
Tabs
Shoulder-
Stud
CONTINUE
1-8
Setup and Operator Guide