Rear View; Side Panels - Watchguard Firebox X20E User Manual

Hardware Description
Status
The status indicator shows a management connection to the Firebox X Edge e-Series. The light
goes on when you use your browser to connect to the Firebox X Edge e-Series configuration
pages. The light goes off a short time after you close your browser.
Mode
The mode indicator shows the status of the external network connection. The light comes on
when the Ethernet cable is correctly connected to the WAN1 interface. The light is green if the
Firebox X Edge e-Series can connect to the external network and send traffic. The light flashes if
the Firebox X Edge e-Series cannot connect to the external network and send traffic.
Attn
The Attn indicator will light when you reset the Firebox X Edge e-Series to factory default
settings.
Power
The power indicator shows that the Firebox X Edge e-Series is on.

Rear view

Ethernet interfaces LAN0 through LAN2
The Ethernet interfaces with the marks LAN0 through LAN2 are for the trusted network.
OPT interface
This Ethernet interface is for the optional network.
WAN interfaces 1 and 2
The WAN1 and WAN2 interfaces are for external networks.
Power input
A 12V/1.2A power supply is included with your Firebox X Edge e-Series. Connect the AC adapter
to the Firebox X Edge and to a power source. The power supply tip is plus (+) polarity.
RESET button
To reset the Firebox X Edge e-Series, use the procedure in "Factory Default Settings" on page 37.

Side panels

Computer lock slot
The two side panels of the Firebox X Edge e-Series have a slot for a computer lock.
Antennas (wireless model only)
The two side panels of the Firebox X Edge e-Series Wireless have wireless antennas.
Wall mounting plate (wireless model only)
The wall mounting plate enables you to put the Firebox X Edge e-Series in a good location to
increase the range.
234 Firebox X Edge e-Series