Local Restart; Remote Restart; Setting The System Time - Watchguard Firebox X20E User Manual

Local restart

You can locally restart the Firebox X Edge e-Series with one of two methods: use the web browser, or
disconnect the power supply.
Using the web browser
To connect to the System Status page, type https:// in the browser address bar, and then the IP
1
address of the Firebox X Edge trusted network interface.
The default URL is: https://192.168.111.1
Click Reboot.
2
Disconnecting the power supply
Disconnect the Firebox X Edge power supply. Wait for a minimum of 10 seconds, and then connect the
power supply again.

Remote restart

If you want to be able to connect to the Edge to manage it or restart it from a computer external to the
Edge, you must first configure the Edge to allow incoming HTTPS traffic to the Edge trusted interface IP
address. For more information on how to configure the Edge to receive incoming traffic, see "Enabling
Common Packet Filter Policies" on page 93. Remember that, if you enable HTTPS connections to the
Edge, anyone who has the correct credentials can also connect to the Edge. After HTTPS traffic is
allowed, you can remotely manage your Edge using your browser from a trusted IP address. To do a
remote restart:
To connect to the System Status page, type https:// in the browser address bar, and then the IP
1
address of the Firebox X Edge external interface.
The default URL is: https://192.168.111.1.
Type your user name and passphrase. You must log in as the Edge administrator, or as a user
2
with administrative access.
On the System Status page, click Reboot.
3

Setting the System Time

Network Time Protocol (NTP) synchronizes computer clock times across a network. The Edge uses NTP
to get the correct time automatically from NTP servers on the Internet. Because the Edge records the
time from its system clock in each log message it generates, it is important that the time is set correctly.
User Guide
Setting the System Time
39