Memory; Processes; Protocols; Routes - Watchguard Firebox X20E User Manual

Monitoring the Firebox X Edge
Maximum use - maximum number of users allowed by the license
•
Reboot - shows if a reboot is necessary after a configuration change for that license
•
Expiration - shows when the license expires
•
Comment
•

Memory

This status page shows the state of the linux kernel memory.

Processes

This status page shows all processes that run on the Edge. It also shows the load average for the CPU.
Averages are shown in 1-minute, 5-minute, and 15-minute increments.
PID
Process ID, a unique number that shows when the process started.
NAME
Name of the process.
STATE
State of the process:
R - running
S - sleeping
D,Z - inactive
RSS
Total number of kilobytes of physical memory used by the process.
SHARE
Total number of kilobytes of shared memory used by the process.
TIME
Time that the process has used since the last time the Edge was started.
CPU
Percentage of CPU time used by the process since the last time the Edge was rebooted.
PRI
Priority of the process. A lower number has a higher priority for CPU resources.
SCHED
Measure of how the kernel schedules the process.

Protocols

This status page shows the protocol statistics for IP, ICMP, TCP, and UDP.

Routes

This status page shows the Edge routing table.
Interface
Interface associated with the route.
Network
Network that the route has been created for.
34 Firebox X Edge e-Series