Windows 2000 Setup - Watchguard Firebox X20E User Manual

Firmware version 8.6 all firebox x edge e-series standard and wireless models
Hide thumbs Also See for Firebox X20E:
Table of Contents

Advertisement

If the MUVPN client does not use the virtual adapter, the remote computer must have your network's
private WINS and DNS server IP addresses listed in the Advanced TCP/IP Properties of the primary Inter-
net connection.

Windows 2000 setup

Use this section to install and configure the network components for the Windows 2000 operating sys-
tem. These components must be installed before you can use the MUVPN client on a Windows 2000
computer. From the Windows desktop:
Select Start > Settings > Network and Dial-up Connections.
1
Right-click the connection you use to get Internet access and select Properties.
2
The connection properties window appears.
Click the Networking tab.
3
Make sure these components are installed and enabled:
4
- Internet Protocol (TCP/IP)
- File and Printer Sharing for Microsoft Networks
- Client for Microsoft Networks
To enable a component, click the adjacent check box. If a component is not installed, use the
instructions to install it.
Installing the Internet Protocol (TCP/IP) network component on Windows
2000
From the connection window Networking tab:
Click Install.
1
The Select Network Component Type window appears.
Double-click the Protocol network component.
2
The Select Network Protocol window appears.
Below the Microsoft manufacturer, select the Internet Protocol (TCP/IP) network protocol and
3
click OK.
Installing the File and Printer Sharing for Microsoft Networks on Windows
2000
From the connection window Networking tab:
Click Install.
1
The Select Network Component Type window appears.
Double-click the Services network component.
2
The Select Network Service window appears.
Below the Microsoft manufacturer, select the File and Printer Sharing for Microsoft Networks
3
network service and click OK.
Installing the Client for Microsoft Networks on Windows 2000
From the connection window Networking tab:
Click Install.
1
The Select Network Component Type window appears.
Double-click the Client network component.
2
The Select Network Protocol window appears.
User Guide
Configuring IPSec Mobile User VPN
215

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents