Monitoring The Firebox X Edge; Arp Table - Watchguard Firebox X20E User Manual

Monitoring the Firebox X Edge

Monitoring the Firebox X Edge
When you expand System Status on the navigation bar, you see a list of monitoring categories. With
these pages, you can monitor all the components of the Edge and how they work.
The Firebox® X Edge monitor pages are not set to refresh automatically. If you want a page to refresh
automatically, click the Start Continuous Refresh or Restart Continuous Refresh button at the top of
the page. The page refreshes until you click Pause Continuous Refresh or you navigate to a new page.
You can see a small counter below the button that shows the number of times the page has been
refreshed.

ARP Table

This status page shows devices that have responded to an ARP (Address Resolution Protocol) request
from the Edge:
IP Address
IP address of the computer that responds to the ARP request.
HW type
Type of Ethernet connection that the IP address uses to connect.
Flags
If the hardware address of the IP resolves, it is marked as valid. If it does not, it is marked as
invalid.
A valid hardware address can briefly show as
request.
HW Address
MAC address of the network interface card that is associated with the IP address.
30
invalid
while the Edge waits for a response for the ARP
Firebox X Edge e-Series