Table of Contents
Advertisement
Table 5. 4U PCIe Riser Cages and corresponding PCIe slots (continued)
Slot 9
Slot 10
Riser cage 2
4
Slot 11
Slot 12
2
/
3
7mm drive bays
Install 7mm drives to these bays. See
5
AC power LED (green)
Each hot-swap power supply unit comes with one AC and one DC power LED. When the AC power LED is lit,
it indicates that sufficient power is being supplied to the power supply through the power cord. During
normal operation, both the AC and DC power LEDs are lit.
6
DC power LED (green)
Each hot-swap power supply unit comes with one AC and one DC power LED. When the DC power LED is lit,
it indicates that the power supply is supplying adequate dc power to the system. During normal operation,
both the AC and dc power LEDs are lit.
7
Power supply error LED (yellow)
When the power supply error LED is lit, it indicates that the power supply has failed.
Power supply units
8
Install power supply units to these bays, connect them to power cords. Make sure the power cords are
connected properly. Following are the power supplies supported by this system:
• 750-watt Platinum, input power 115 Vac / 230 Vac / 240 VDC
• 750-watt Titanium, input power 230 Vac / 240 VDC
Note: When only two units of 750-watt Titanium power supply are installed, 240 VDC is not supported.
• 1100-watt Platinum, input power 115 Vac / 230 Vac / 240 VDC
• 1100-watt Titanium, input power 230 Vac / 240 VDC
• 1800-watt Platinum, input power 230 Vac / 240 VDC
• 1800-watt Titanium, input power 230 Vac / 240 VDC
• 2600-watt Titanium, input power 230 Vac / 240 VDC
9
/
10
/
11
PCI Express 3.0
Install adapters, particularly RAID adapters, to these slots.
12
Serial connector
Connect a 9-pin serial device to this connector. The serial port is shared with XCC. XCC can take control of
the shared serial port to redirect serial traffic, using Serial over LAN (SOL).
13
VGA connector
Connect a monitor to this connector.
Notes:
• When the optional front VGA connector is in use, the rear one will be disabled.
• The maximum video resolution is 1920 x 1200 at 60 Hz.
ThinkSystem SR860 V2 Maintenance Manual
24
"Install a 7mm drive" on page 268
NA
Slot 10
NA
Slot 12
for more details.
Advertisement
Table of Contents
