Figure 98. Loosening T-shaped heat sink screws
Step 3.
Remove the PHM from the system board.
Figure 99. Removing a PHM
Fully loosen the Torx T30 nuts on the PHM in the removal sequence shown on the heat-sink
label.
Rotate the anti-tilt wire bails inward.
Carefully lift the PHM from the processor socket. If the PHM cannot be fully lifted out of the
socket, further loosen the Torx T30 nuts and try lifting the PHM again.
Notes:
• Do not touch the contacts on the bottom of the processor.
• Keep the processor socket clean from any object to prevent possible damages.
ThinkSystem SR860 V2 Maintenance Manual
210