Table of Contents
Advertisement
Align the slot on the rear of the backplane with the rear pin on the bracket, and lower the
other side of the backplane.
Align the captive screw on the backplane to the front pin on the bracket.
Tighten the captive screw with a screw driver to secure the backplane to the bracket.
Step 5.
Align the end of the M.2 backplane to the slot on the PCIe expansion tray, and pivot the other end
towards the tray until the bracket clicks in place.
Figure 175. Installing the M.2 backplane bracket assembly
Step 6.
Connect the M.2 signal and power cable to the system board.
.
Chapter 4
Hardware replacement procedures
281
Advertisement
Table of Contents
