Lenovo ThinkSystem SR860 V2 Maintenance Manual page 239

Figure 123. Removing the system board
After this task is completed
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Important: Before returning the system board, make sure that you install the processor socket dust
covers from the new system board. To replace a processor socket dust cover:
1. Take a dust cover from the processor socket assembly on the new system board, and orient it
correctly above the processor socket assembly on the removed system board.
2. Gently press down the dust cover legs to the processor socket assembly, pressing on the edges to
avoid damage to the socket pins. You might hear a click on the dust cover is securely attached.
3. Make sure that the dust cover is securely attached to the processor socket assembly.
• If you are planning to recycle the system board, follow the instructions in
for recycle" on page 231
Demo video
Watch the procedure on YouTube
Disassemble the system board for recycle
Follow the instructions in this section to disassemble the processor and memory expansion tray before
recycle.
About this task
Attention:
• Go over "Installation Guidelines" on page 137
for compliance with local regulations.
to ensure that you work safely.
"Disassemble the system board
.
Chapter 4 Hardware replacement procedures
231