Table of Contents
Advertisement
• If the processor is located on the system board:
1. Remove one of the following components.
– System air baffle (see
– Processor and memory expansion tray and expansion tray air baffle (see
2. Remove the expansion tray air baffle.
Figure 59. Removing the expansion tray air baffle
d.
Remove the PHM. See
Step 2.
Remove the Torx T30 nut.
Figure 60. Removing a Torx T30 nut from the heat sink
Note: Do not touch the gold contacts on the bottom of the processor.
a.
Rotate the anti-tilt wire bail inwards.
b.
Push the upper edge of the Torx T30 nut towards the center of the heat sink until it
disengages.
c.
Remove the Torx T30 nut.
"Remove the system board air baffle" on page
the processor and memory expansion tray" on page
"Remove a processor and heat sink" on page
219)
206.
.
Chapter 4
Hardware replacement procedures
226)
"Remove
169
Advertisement
Table of Contents
