Table of Contents
Advertisement
Procedure
Step 1.
Gently rotate the release latch away to unlock the drive handle.
Figure 33. Removing a 2.5-inch drive
Step 2.
Grasp and pull the handle to remove the drive from the drive bay.
After this task is completed
1. Install a replacement unit or filler (see
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Demo video
Watch the procedure on YouTube
Remove a drive backplane carrier assembly
Follow instructions in this section to remove a drive backplane carrier assembly.
About this task
Attention:
• Go over
"Installation Guidelines" on page 137
• Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
"Power off the server" on page
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack.
Procedure
Step 1.
Make preparations for this task.
a.
Remove the top cover (see
"Install a 2.5-inch hot-swap drive" on page
to ensure that you work safely.
12).
"Remove the top cover" on page
146).
240).
.
Chapter 4
Hardware replacement procedures
141
Advertisement
Table of Contents
