Table of Contents
Advertisement
Figure 35. Removing drive backplanes from the carrier
After this task is completed
1. Install a replacement unit (see
corresponding drive bays with drive fillers.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Demo video
Watch the procedure on YouTube
Install a drive backplane carrier assembly
Follow instruction in this section to install a drive backplane carrier assembly.
About this task
Attention:
• Go over
"Installation Guidelines" on page 137
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Procedure
Step 1.
If necessary, install each backplane to the carrier with two screws.
ThinkSystem SR860 V2 Maintenance Manual
144
"Install a drive backplane carrier assembly" on page
to ensure that you work safely.
144), or fill the
Advertisement
Table of Contents
