Install a flash power module
Follow instructions in this section to install a flash power module.
About this task
Note:
Figure 165. Available flash power module slots for 9350-8i and 9350-16i RAID adapters
When 9350-8i or 9350-16i RAID adapter is installed, only the middle two slots are available for flash power
module. Make sure to install the flash power module into these two slots.
Attention:
• Go over
"Installation Guidelines" on page 137
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Procedure
Step 1.
Press on the retaining latch; then, align the flash power module with the slot in the PCIe expansion
tray, and push it in.
ThinkSystem SR860 V2 Maintenance Manual
274
to ensure that you work safely.