Table of Contents
Advertisement
About this task
Attention:
• Go over
"Installation Guidelines" on page 137
• Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
"Power off the server" on page
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack.
Procedure
Step 1.
Make preparations for this task.
a.
Remove the top cover (see
b.
Remove both PCIe riser cages or fillers, the chassis air baffle, and the PCIe expansion tray (see
"Remove a 4U PCIe riser cage" on page
"Remove the 4U PCIe expansion tray" on page
c.
Disconnect cables that are connected to the adapters.
Step 2.
Grasp and lift the PCIe riser assembly to remove it from the system board.
Figure 76. Removing the PCIe riser assembly
After this task is completed
• Fill the riser slot with a replacement unit or a filler (see
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
to ensure that you work safely.
12).
"Remove the top cover" on page
255,
"Install the PCIe riser assembly" on page
240).
"Remove the chassis air baffle" on page
249).
.
Chapter 4
Hardware replacement procedures
270, and
193).
187
Advertisement
Table of Contents
