Lenovo ThinkSystem SR860 V2 Maintenance Manual page 235

• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack.
Procedure
Step 1. Make preparations for this task.
a. Remove the top cover (see
b. Remove both PCIe riser cages or fillers, the chassis air baffle, and the PCIe expansion tray (see
"Remove a 4U PCIe riser cage" on page
"Remove the 4U PCIe expansion tray" on page
Step 2. Lift the system air baffle to remove it from the server.
Figure 120. Removing the system board air baffle
After this task is completed
• Install the processor and memory expansion tray (see
on page 223).
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Demo video
Watch the procedure on YouTube
Install the system board air baffle
Follow instructions in this section to install the system board air baffle.
About this task
"Remove the top cover" on page
255, "Remove the chassis air baffle" on page
249).
"Install the processor and memory expansion tray"
Chapter 4
240).
.
Hardware replacement procedures
270, and
227