Table of Contents
Advertisement
1 Adjust the seat cushion incli-
nation so that the front edge of
the seat cushion is in the high-
est position and the rear edge
of the seat cushion is in the low-
est position.
2 The vehicle is equipped with
automatic front passenger air-
bag shutoff. The PASSENGER
AIR BAG OFF indicator lamp
must be lit.
X Not suitable for children in
this weight category.
U Suitable for child restraint
systems of the "Universal" cate-
gory in this weight category.
L Suitable for semi-universal
child restraint systems accord-
ing to the table in "Recommen-
ded child restraint systems", or
if the vehicle and the seat are
listed in the child restraint sys-
tem manufacturer's vehicle
model list.
UF Suitable for forward-facing
child restraint systems of the
"Universal" category in this
weight category.
Securing the child restraint system
Adjusting the seat correctly
When fitting a child restraint system on the left or
right rear seat, always observe the following:
Make sure that the child's feet do not touch
#
the front seat. If necessary, move the front
seat slightly forwards.
F118 0058 02
Children in the vehicle – Securing the child restraint system 131
If the head restraint of the child restraint system
cannot be fully extended when it is installed in the
vehicle, this will result in restrictions on the maxi-
mum size setting for certain child restraint sys-
tems. Observe the child restraint system manu-
facturer's installation instructions.
%
Contact with the roof when the head restraint
is fully extended and locked in place will not
result in any restrictions on use.
®° When fitting an ISOFIX/LATCH or
i‑Size child restraint system, also observe the fol-
lowing:
When using a rearward-facing child restraint
#
system on a rear seat: adjust the front seat so
that it does not touch the child restraint sys-
tem.
When using a forward-facing child restraint
#
system with integrated child seat belt: adjust
the head restraint of the respective seat so
that it does not push the child restraint system
forwards. If necessary, the respective head
restraint can be removed. In addition, the
backrest of the child restraint system must lie
as flat as possible against the backrest of the
Advertisement
Table of Contents
