Table of Contents
Advertisement
590 Breakdown assistance
Remove the valve cap from valve
#
faulty tyre.
Screw filling hose
8
onto valve 7.
#
7
on the
Insert plug
#
cle.
Switch on the vehicle.
#
Switch on the tyre inflation compressor using
#
On/Off switch 3.
The tyre is inflated. First, tyre sealant is pum-
ped into the tyre. The pressure may briefly rise
to approximately 500 kPa (5.0 bar/73 psi).
4
into a 12‑V‑socket in your vehi-
F118 0058 02
Do not switch off the tyre inflation compressor
during this phase!
Let the tyre inflation compressor run for a
#
maximum of ten minutes.
The tyre should then have attained a tyre pres-
sure of at least 200 kPa (2.0 bar/29 psi).
If tyre sealant leaks out, make sure you clean the
affected area as quickly as possible. It is prefera-
ble to use clean water.
If you get tyre sealant on your clothing, have it
cleaned as soon as possible with perchloroethy-
lene.
If, after ten minutes, a tyre pressure of 200 kPa
(2.0 bar/29 psi) has not been attained:
Switch off the tyre inflation compressor.
#
Unscrew the filling hose from the valve of the
#
defective tyre.
Please note that tyre sealant may leak out when
unscrewing the filling hose.
Drive forwards or in reverse very slowly for
#
approximately 10 m.
Advertisement
Table of Contents
