Table of Contents
Advertisement
354 Driving and parking
If there is dirt on the windscreen in the vicinity
R
of the multifunction camera or if the camera is
misted up, damaged or obscured.
If the traffic signs are difficult to see because,
R
forexample, they are dirty, obscured, faded,
iced over, damaged, inconveniently positioned,
insufficiently illuminated or askew.
Active traffic signs with LED displays may not
R
be detected correctly, or even at all due to
technical factors, suchas transmission fre-
quency.
If the information on the navigation system's
R
digital map is incorrect, incomplete or out of
date.
If the signs, road markings or road layout are
R
ambiguous, e.g. in the case of traffic signs at
road works, at exits and on-ramps, in the case
of adjacent lanes or parallel roads, in the case
of pedestrian crossing markings at traffic
lights.
If the signage or road markings do not comply
R
with the standard.
If the signage, road markings, or road guid-
R
ance is country-specific and deviates from the
navigation system's route guidance, e.g. at or
after road works.
After sharp turns and tight bends, if traffic
R
signs are outside the camera's field of vision.
If you overtake vehicles with traffic signs
R
affixed or attached to them.
If you use transport equipment secured to the
R
vehicle with a trailer coupling, suchas a bicy-
cle rack, restrictions for vehicle/trailer combi-
nations may be considered valid as applicable.
▌Setting Traffic Sign Assist
Multimedia system:
©
Settings
Assistance
4
5
5
Assistance
Traffic Sign Assist
5
5
Activating or deactivating the speed limit warning
%
The speed limit warning is switched on by
default (depending on the country).
Switch off
Speed limit warning
#
Following country-specific legislation, the
speed limit warning remains deactivated until
the next time the vehicle is switched on or off.
F118 0058 02
%
The audible speed limit warning can also be
switched off and on via quick-access, by
pressing and holding the mute button on the
steering wheel, by pressing the speed icon in
the status line of the media display or via a
voice control command (availability of func-
tions depending on respective country).
Change the type of speed limit warning
Change the warning to
#
audible.
Setting the warning threshold
This value determines the speed at which a warn-
ing is issued when exceeded.
Set the desired speed under warning thresh-
#
old.
%
Availability of the function is subject to coun-
try-specific legislation.
Switching the acoustic signal for a new maximum
.
permissible speed on or off
%
The acoustic signal for a new maximum per-
missible speed is switched off at the factory.
Visual
or
Visual &
Advertisement
Table of Contents
