Table of Contents
Advertisement
these exhaust gases is hazardous to health
and results in poisoning.
Never leave the engine and, if present,
#
the stationary heater, running in an
enclosed space without sufficient venti-
lation.
& WARNING Risk of injury by becoming
trapped when opening and closing a
garage door
When you operate or program a garage door
with an integrated garage door opener, per-
sons can become trapped or struck by the
garage door if they stand within its range of
movement.
Always make sure that nobody is within
#
the range of the garage door's move-
ment.
Before programming the garage door opener, park
the vehicle outside the garage. Make sure that the
vehicle is switched on but not started.
Requirements
The vehicle has been parked outside the
R
garage or outside the range of movement of
the door.
The vehicle is switched on.
R
The vehicle has not been started.
R
%
The garage door opener function is always
available when the vehicle is switched on.
F118 0058 02
Driving and parking 305
Press and hold button 1,
2
#
wish to program.
Indicator lamp
4
flashes yellow.
%
It can take up to 20 seconds before the indi-
cator lamp flashes yellow.
Release the previously pressed button.
#
Indicator lamp
4
continues to flash yellow.
Point remote control
5
from a distance of
#
1 cm to 8 cm towards button 1,
Press and hold button
6
of remote control
#
5
until one of the following signals appears:
Indicator lamp
4
lights up green continu-
R
ously. Programming is complete.
Indicator lamp
4
flashes green. Program-
R
ming was successful. Additionally, syn-
chronisation of the rolling code with the
door system must be carried out.
If indicator lamp
4
does not light up or flash
#
green: repeat the procedure.
Release all of the buttons.
#
or
3
that you
2
or 3.
Advertisement
Table of Contents
