Table of Contents
Advertisement
Front passenger airbag disabled
Weight category I: 9 to 18 kg
Front passenger airbag enabled
Front passenger airbag disabled
Weight category II: 15 to 25 kg
Front passenger airbag enabled
Front passenger airbag disabled
Weight category III: 22 to 36 kg
Front passenger airbag enabled
Front passenger airbag disabled
1 Adjust the seat cushion inclination so that the front edge of the
seat cushion is in the highest position and the rear edge of the seat
cushion is in the lowest position.
2 The vehicle is equipped with automatic front passenger airbag
shutoff. The PASSENGER AIR BAG OFF indicator lamp must be lit.
Securing the child restraint system
U, L
1, 2
Adjusting the seat correctly
When fitting a child restraint system on the left or
1
UF, L
right rear seat, always observe the following:
Make sure that the child's feet do not touch
1, 2
U, L
#
the front seat. If necessary, move the front
seat slightly forwards.
1
UF, L
If the head restraint of the child restraint system
cannot be fully extended when it is installed in the
1, 2
U, L
vehicle, this will result in restrictions on the maxi-
mum size setting for certain child restraint sys-
tems. Observe the child restraint system manu-
facturer's installation instructions.
UF, L
1
%
Contact with the roof when the head restraint
1, 2
U, L
is fully extended and locked in place will not
result in any restrictions on use.
®° When fitting an ISOFIX or i‑Size child
restraint system, also observe the following:
When using a rearward-facing child restraint
#
system on a rear seat: adjust the front seat so
that it does not touch the child restraint sys-
tem.
Safely transporting children in the vehicle
When using a forward-facing child restraint
#
system with integrated child seat belt: adjust
the head restraint of the respective seat so
that it does not push the child restraint system
forwards. If necessary, the respective head
restraint can be removed. In addition, the
backrest of the child restraint system must lie
as flat as possible against the backrest of the
vehicle seat. After the child restraint system
has been removed, replace the vehicle head
restraint immediately and adjust correctly.
The child restraint system must not be put
#
under strain between the roof and the seat
cushion and/or be fitted facing the wrong
direction. Where possible, adjust the seat
cushion inclination accordingly.
Adjust the vehicle head restraints so that the
#
child restraint system is not put under strain
by the head restraint.
7 When fitting a belt-secured child restraint
system, also observe the following:
When using a rearward-facing child restraint
#
system on a rear seat: adjust the front seat so
63
Advertisement
Table of Contents
