Table of Contents
Advertisement
620 Wheels and tyres
Remove socket
2
and wheel wrench
#
the vehicle tool kit.
Position socket
2
on hub cap 1.
#
Position wheel spanner
3
on socket 2.
#
Using wheel spanner 3, turn hub cap
#
anti-clockwise and remove it.
Fitting
Before fitting, check hub cap
#
wheel area for dirt, and clean if necessary.
Position hub cap
1
and turn until it is in the
#
right position.
Position socket
2
on hub cap 1.
#
Position wheel wrench
3
on socket
#
tighten hub cap 1.
%
Specified tightening torque: 25 Nm.
Removing and fitting the wheel trim/hub caps
Requirements
The vehicle is prepared for a wheel change
R
(
page 619).
/
3
from
Plastic hub cap
To remove:
Turn the centre cover of the hub cap anti-
#
clockwise and remove the hub cap.
1
To fit:
Make sure that the centre cover of the hub
#
cap is turned anti-clockwise.
Position the hub cap and turn the centre cover
#
1
and the
clockwise until the hub cap engages physically
and audibly.
Aluminium hub cap
2
and
To remove:
F118 0058 02
Position socket
2
from the tyre-change tool
#
kit on hub cap 1.
Position wheel spanner
3
on socket 2.
#
Using wheel spanner 3, turn hub cap
#
anti-clockwise and remove it.
To fit:
Follow the instructions above in reverse order.
#
%
Specified tightening torque: 25 Nm.
Raising the vehicle when changing a wheel
Requirements
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
R
change (
page 619).
/
Important notes on using the jack:
Use only a vehicle-specific jack that has been
R
approved by Mercedes-Benz to raise the vehi-
cle.
The jack is only designed for raising and hold-
R
ing the vehicle for a short time while a wheel
1
Advertisement
Table of Contents
