Table of Contents
Advertisement
2 Press [F], press and hold [TONE].
"
•
Scan starts and
Scanning
•
To quit the scan, press [ ].
•
When a DCS code is identified, the identified code
appears on the display and blinks.
3 Press [A/B] to program the identified code in place of the
currently set DCS code.
•
The DCS function will remain on. To cancel DCS, press
[TONE] until DCS no longer appears on the display.
CROSS TONE
Using Cross Tone
You can set separate signaling types by TX and RX for when
you access a repeater that uses different Encode/ decode
signaling.
To turn the Cross Tone function On:
1 Press [TONE] 4 times to activate the Cross Tone function.
•
The <
(default) icon appears on the display when
>
the Cross Tone function is On.
•
Each time you press [TONE], the selection changes as
follows:
Tone (
) CTCSS (
Tone (
: default) Off (no display).
•
Additionally, when APRS is ON and Voice Alert is
configured, Voice Alert ON is added to the above cycle.
Selecting a Cross Tone mode
To select the cross tone/code frequency required to access
your desired repeater:
1 Turn the Cross Tone function On.
2 Press [F], [TONE].
•
The Cross Tone setting appears on the display.
3 Select your desired Cross Tone setting.
Setting
Encode
DCS/Off
DCS
TONE/DCS
Tone
DCS/CTCSS
DCS
TONE/CTCSS
Tone
4 Press [A/B] to set the selected setting.
"
blinks on the display.
) DCS (
) Cross
Decode
Icon
off
DCS
CTCSS
CTCSS
10-3
Advertisement
Table of Contents
