KEY BEEP
You can set the transceiver beep function to [Off] or [On].
1 Access Menu No. 914.
2 Select [On] or [Off].
Note:
¡ Even with the beep function turned off, the transceiver will beep
1 minute before the power turns off when Auto Power off is
activated.
¡ After transmitting for the maximum time duration according to
the Time-out Timer, the transceiver will beep.
BEEP VOLUME
You can set the beep volume.
The volume level can be changed by VOL Link (Linked with
[VOL] control.), and set by a value among "Level 1" to "Level
7". A larger value results in a greater volume.
1 Access Menu No. 915.
2 Select [VOL Link] or [Level 1] - [Level 7].
BATTERY SAVER
The Battery Saver extends the operating time of the
transceiver. It automatically activates when the squelch is
closed and no key is pressed for more than 5 seconds. To
reduce battery consumption, this function shuts the receiver
circuit OFF for the programmed time, then momentarily turn it
back ON to detect a signal.
To program the receiver shut-off period for the battery saver:
1 Access Menu No. 920.
2 Select [0.2], [0.4], [0.6], [0.8], [1.0], [2.0], [3.0], [4.0], [5.0]
seconds, or [Off].
AUTO POWER OFF (APO)
Automatic Power off is a background function that monitors
whether or not any operations have been performed (keys
pressed, [ENC] control turned, etc.), and turns the transceiver
power off if it has not been in use.
To program the receiver shut-off period for the battery saver:
1 Access Menu No. 921.
2 Set the APO time limit to [15], [30], [60] minutes, or [Off].
•
After the time limit passes with no operations (default
is [Off]), APO turns the transceiver power off. However,
1 minute before the power turns off, [APO] appears on
the display and blinks, and a warning tone sounds.
Note:
¡ A warning tone sounds when a Key Beep is set to Off.
¡ Automatic Power Off does not operate in scanning.
BATTERY LEVEL
You can verify the battery capacity while in Menu mode.
1 Access Menu No. 922.
Note:
¡ You can check the remaining battery level by voice guidance.
Rrefer to page No.23-1 SETTING VOICE GUIDANCE MODE
section.
CHARGING
You can set whether to charge the battery pack when a DC IN
cable or USB cable is connected while the power is ON.
1 Access Menu No. 923.
2 Select [On] or [Off].
[Off]:
Does not charge when the power is ON.
[On]:
Charges even when the power is ON.
Note:
¡ When the power is off, the battery will be charged
regardless of the settings.
12-9