Table of Contents
Advertisement
From the Menu:
1 Access Menu No. 151.
2 Select the desired VOX gain level.
VOX Delay Time
If the transceiver returns to reception mode too quickly after
you stop speaking, the end of your transmission may not be
sent. To avoid this, select an appropriate delay time that allows
your entire transmission to be sent, before Transmit mode
ends. However, do not make the delay overly long.
There are 2 ways to adjust the VOX Delay Time.
While the VOX function is ON:
1 Press [ ]/[
] to change the delay time to 250, 500, 750,
1000, 1500, 2000, or 3000 ms.
From the Menu:
1 Access Menu No. 152.
2 Select [250], [500], [750], [1000], [1500], [2000], or [3000]
ms.
Note:
[PTT]
¡ If you press
while the VOX function is ON, the VOX Delay
Time is not reflected to the transmission.
[CALL]
¡ If you press
(if 1750 Hz is programmed) to transmit a
1750 Hz tone, the VOX Delay Time is not reflected.
¡ If the DCS function is ON, the transceiver remains in Transmit
mode for the duration set by the VOX Delay Time. It then sends a
Turn-Off Code to close the receiving party's squelch.
VOX on Busy
You can configure the transceiver to force VOX transmission
even if the transceiver is receiving a signal.
1 Access Menu No. 153.
2 Select [On] or [Off].
[Off]: Do not operate VOX when the operation band is
busy.
[On]: Operate VOX when the operation band is busy.
Note:
[PTT]
¡ You can press
transmit, regardless of the setting in Menu No. 153.
PITCH FREQUENCY
This function set the pitch frequency during CW reception.
1 Access Menu No. 170.
2 Select among from [400] to [1000] Hz.
CW REVERSE
You can select the USB side [Normal] or LSB side [Reverse].
1 Press [MODE] to set CW mode.
2 Access Menu No. 171.
3 Select [Reverse] or [Normal].
12-5
[CALL]
or
(if 1750 Hz is programmed) to
Advertisement
Table of Contents
