Table of Contents
Advertisement
3 PREPARATION
SUPPLIED ACCESSORIES
After carefully unpacking the transceiver, identify the items
listed in the table below. We recommend you keep the box and
packaging for shipping.
Item
Comments
Antenna
KNB-75LA:
Li-ion battery pack
1820 mAh
W0H-0160-XX
Charger
(AC Voltages: 100 - 240 V,
W0H-0161-XX
50/60 Hz)
W0H-0162-XX
Belt clip
2 screws supplied
Warranty card
English/ French/
Spanish
User guide
Italian/ German/
Dutch
INSTALLING THE ANTENNA
Hold the supplied antenna by its base, then screw it into the
connector on the top panel of the transceiver until secure.
INSTALLING THE BATTERY PACK
Note:
¡ Because the battery pack is provided uncharged, you must
charge the battery pack before using it with the transceiver.
¡ When removing the battery pack, be careful not to drop the
transceiver and the battery pack.
¡ When installing/removing the battery pack, be careful not to
damage your nails or fingers.
Match the guides of the battery pack with the corresponding
grooves on the upper rear of the transceiver, then firmly press
the battery case to lock it in place.
To remove the battery pack, lift the release lever to unlock the
battery pack. Lift the battery pack away from the transceiver.
INSTALLING ALKALINE BATTERIES
1 To open the optional KBP-9 battery case lid, press the
Quantity
TH-D75E
TH-
D75A
E
T
1
1
1
1
1
1
1
–
–
–
1
–
2 Insert (or remove) six AAA (LR03) Alkaline batteries.
–
–
1
1
1
1
1
1
1
1
1
1
3 Align the two tabs at the bottom of battery case, then close
–
1
–
4 To install the battery case onto (or remove it from) the
Note:
¡ Do not use Manganese batteries or Rechargeable batteries in
¡ Remove all batteries from the case when it is not expected to be
¡ To lift the battery pack safety catch, use a piece of hardened
INSTALLING THE BELT CLIP
If desired, you can install the supplied belt clip to the
transceiver.
Attach the belt clip firmly using the two supplied M3 x 6 mm
binding screws.
Note ：
¡ Be careful not to pinch your fingers into the belt clip.
¡ Check occasionally to see if the screws are loose.
•
3-1
release lever on the top of the battery case, then pull the
cover up.
c
a
•
When removing the Alkaline batteries from the battery
case, pull up on the batteries from the positive (+)
terminal.
•
Be sure to match the battery polarities with those
marked in the bottom of the battery case.
the cover until the locking tabs on top click.
transceiver, follow "INSTALLING THE BATTERY PACK".
place of Alkaline batteries.
in use for several months.
plastic or metal, such as a screwdriver, that is no more than
6 mm wide and 1 mm thick. It is imperative that you place the
implement under only the lip of the safety catch so that you do
not damage the release latch.
Screws
CAUTION
Do not use glue which is designed to prevent screw
loosening when installing the belt clip, as it may cause
damage to the transceiver. Acrylic ester, which is
contained in these glues, may crack the transceiver's
back panel.
b
Belt clip
Advertisement
Table of Contents
