Table of Contents
Advertisement
9 SCAN
Scan is a useful feature for hands-off monitoring of your
favorite frequencies. Becoming comfortable with all types of
Scan will increase your operating efficiency.
This transceiver provides the following types of scans.
Scan Type
Band Scan
Scans all frequencies on the current band.
Scans all frequencies stored in the Memory
Memory Scan
channels.
Scans memory channel in the plural
Group Link
memory groups registered in the group link
Scan
list..
Scans all frequencies within the
Program Scan
programmed range, on the current band.
Scans all frequencies within a 1 MHz range
MHz Scan
from the originating frequency.
Scans the Call channel as well as the
Call Scan
currently selected VFO frequency or
Memory channel.
Priority Scan checks the Priority Channel
Priority Scan
every 3 seconds.
Note:
¡ Adjust the squelch level before using scan. Selecting a squelch
level too low could cause scan to stop immediately.
¡ While using CTCSS or DCS, scan stops for any signal received;
however, scan will immediately resume if the received signal
does not contain the same CTCSS tone or DCS code that you
selected.
[PTT]
¡ Pressing and holding
is functioning on a non TX band.
SELECTING A SCAN RESUME METHOD
The transceiver stops scanning at a frequency or Memory
channel on which a signal is detected. It then continues
scanning according to which resume mode you have selected.
You can choose one of the following modes.
Time-Operated mode
Scan will stop temporarily once the squelch opens. Scan will
resume 5 seconds later (default setting) regardless of the
squelch status.
Carrier-Operated mode
Scan will stop temporarily once the squelch opens. Scan will
resume if the squelch remains closed for more than 2 seconds
(default setting).
Seek mode
Scan will complete once the squelch opens, and it will not
resume.
1 Access Menu No. 130.
•
In digital (DV/DR mode), access Menu No. 131.
2 Set the Scan Resume mode to [Time] (Time-Operated),
[Carrier] (Carrier-Operated) or [Seek] (Seek).
Scan Range
causes scan to temporarily stop if it
Time-Operate Resume Time
Set the hold time for the Time-Operate scan method.
When a signal is received, scan will pause at that frequency
for the duration of the hold time you set. When the set time
elapses, scan will resume (even if the signal is still being
received).
1 Access Menu No. 132.
2 Set the resume time to 1 ~ 10 sec.
Carrier-Operated Resume Time
Set the hold time for the Carrier-Operate scan method.
When a signal is received, scan will pause at that frequency.
When the signal stops, scan will resume after the duration of
the hold time you set.
1 Access Menu No. 133.
2 Set the resume time to 1 ~ 10 sec.
BAND SCAN
Band scan monitors all frequency range that is stored in Menu
No. 100 (Programmable VFO), using the current frequency
step size.
1 Select your desired operation band and frequency.
2 Press and hold [VFO].
Band scan appears and scan starts at the current
frequency.
•
The 1 MHz decimal point blinks while scanning is in
progress.
Note:
¡ When starting a scan within the frequency range of the
registered program scan memory, it is the program scan.
¡ During DR mode, press and hold [VFO], the DR scan menu
screen will appear on the display. (refer to page No.16-14 )
3 To quit band scan, press [VFO].
9-1
Advertisement
Table of Contents
