Table of Contents
Advertisement
Key operations in [GPS satellite information]
Key Name
Switches to [Target point distance and Target
[
]
direction] screen.
Switches to FM radio frequency screen when FM
[
]
radio mode is On.
Switches to [Target point distance and Target
[MODE]
direction] screen.
[MENU]
Switches to the menu screen.
Switches to FM radio frequency screen when FM
[A/B]
radio mode is On
[MARK]
Switches to the registration mode of mark position.
Battery Saver (GPS Save)
This function will turn the GPS power source Off after the
programmed timer expires if position data is not determined
during the maximum catching time (approximately 5 minutes).
To prevent unnecessary battery consumption, when there are
many reception satellites, the GPS is stabilized and position
data can be determined, the GPS power source repeatedly
turns On and Off.
1 Access Menu No. 404.
2 Select [Off], [1], [2], [4], [8] minutes, or [Auto].
[Off]: The built-in GPS receiver function is always On.
[1 min] to [8 min]: When set to 1, 2, 4, or 8 minutes, the
GPS off time starts at the selected duration if position
data is not determined during the maximum catching time
(approximately 5 minutes).
[Auto]: When set to Auto, the GPS Off time starts at 1
minute for the first time, then progresses to 2 minutes, 4
minutes and 8 minutes each additional time. The GPS Off
time remains at 8 minutes thereafter. However, after having
determined your position for the duration, if the GPS cannot
pinpoint your location, the GPS Off time will restart at 1
minute.
Note:
¡ Position precision may be improved by setting the Battery Saver
(GPS Save) function to [Off].
¡ When GPS cannot be received, turn the power ON in a clear
environment (Open Sky).
Operation
GPS Data PC Output
Turn this function on when you want to send the built-in GPS
receiver data (NMEA) from the USB connector or Bluetooth.
1 Access Menu No. 405.
2 Select [Off] or [On].
[Off]: The built-in GPS receiver data (NMEA) is not output
from the USB connector or Bluetooth.
[On]: The built-in GPS receiver data (NMEA) is output from
the USB connector or Bluetooth.
Note:
¡ When the built-in GPS receiver data (NMEA) is output, the
communication speed (baud rate) is maximum 12 Mbps for USB
and maximum 128 kbps for Bluetooth.
¡ You can select USB or Bluetooth by Menu No. 981.
Sentence
Configure the built-in GPS receiver data (NMEA) output to the
PC.
1 Access Menu No. 406.
2 Select [$GPGGA], [$GPGLL], [$GPGSA], [$GPGSV],
[$GPRMC], and/or [$GPVTG].
3 Press [ENT].
Each press adds or removes a check mark.
4 Press [A/B].
Note:
¡ You cannot remove all sentences.
13-3
Advertisement
Table of Contents
