Speco DVR-4TN Manual page 85

User's Manual
Move the cursor to this item and press ENTER, then select a Record mode
using UP / DOWN keys.
A NOTE: After changing the Record Mode setting, the warning message
"This will FORMAT ALL HARD DISKS and LOAD THE FACTORY
DEFAULT CONFIG!" will be shown on the screen. Press ENTER to
confirm the selection, then the unit will start to format the hard disks
and load the factory default settings, or press ESC to abort.
We strongly recommend backing up your programmed configuration
before making any changes on Record Mode settings.
5.4.2 Schedule Setup
This submenu is used to set the day and night time, or weekend recording
schedule. The Night and Day schedules are used to define daytime and
nighttime; the Weekend schedule.is tailored for weekends and holidays.
Select «Schedule Setup» from the Record Setup menu and press ENTER;
the following menu is displayed.
Schedule Setup
1. Day Time Start 06:00
2. Day Time End 18:00
3. Night Time Start 18:00
4. Night Time End 06:00
5. Weekend Schedule YES
6. Weekend Start Fri 18:00
7. Weekend End Mon 06:00
» Make appropriate changes for the start time of the Day Time and Night
Time schedule using the Direction keys.
Press ENTER to confirm the settings or ESC to cancel.
If you want to record over the weekend, choose «YES» to enable the
Weekend Schedule in advance and then set the Weekend Start/End time.
e Press ESC to back to previous page.
5.4.2.1
Day / Night Time Start / End
The Day/Night Start Time determines the durion of day/ night recording time.
Time is indicated in 1-minute increments. The time display format in this menu
is based on the setting of Time Display Mode.
DVR-TNIBTNAGTN/ 16TS/6TT Series
2
85
SPECO TECHNOLOGIES 05/07