Speco DVR-4TN Manual page 99

User's Manual
5.8.1 Load Factory Default
This item is used to load the factory default setting; select «YES? to recall the
factory default setup configuration from the "read-only" memory, or «NO» to
cancel.
5.8.2 Import Configuration
This item allows the user to load a unit configuration that was saved on an
external drive. To import a configuration that was previously exported, make
sure the device that saved the configuration is connected to the unit. Select
<Import Config> from the Configuration
menu
and press ENTER.
The
following menu is displayed.
Import Config
Config Name
Select
XXXX-XXXX NO
XXX-XX NO
Press UP / DOWN to select one of the available listed configuration files, and
choose <YES> to start to import.
NOTE: If the imported configuration has a different record mode from
the unit's, the warning message "This config has different record mode.
This will FORMAT ALL HARDDISKS." will show.
NOTE: Remove the ThumbDrive® used for importing
configuration after the unit restarts, or it will be formatted as well.
5.8.3 Export Configuration
The Administrator is allowed to save a unit configuration by exporting it to an
external drive, such as a USB Flash Drive. Before exporting the configuration,
make sure the device in which the configuration will be saved is attached to
the unit properly. Select «Export Config» from the Configuration menu and
press ENTER. The following menu is displayed.
Export Config
^. Copy Destination
2. Config Name
3. Begin Export NO
Items in this menu are described in the following sections.
DVR-A4TNIBTN/IGTN/ 16TS/16TT Series
99
SPECO TECHNOLOGIES 05/07