Speco DVR-4TN Manual page 88

User's Manual
5.4.4.5
5.4.4.6
5.4.5
88
Event Qity
This item is used to set the picture size for event status recording. Refer to
Section 5.4.4.3 for the available options.
Event Active
Users are allowed to choose which alarm type needs to be recorded. The
available options are «Alarm» (alarm events), «Motion» (motion detection
events), «Both» (alarm event * motion detection), and «None» (no events
active). The default setting is «Both», which includes Alarm and Motion event
recording.
ezRecord Setup
This item aims to avoid the complicated record settings and to make the setup
much easier. Note that this item can be reached only when you select
<ezRecord> as the option for <Preset Config». For more information, please
refer to the Appendix J: ezRecord Diagram Sample.
Select «ezRecord Setup» from «Record Setup» and press ENTER, the
Sub-menu appears as shown below:
ezRecord Setup
How Many Days To Record 2 Days
Daytime Record Yes
Night Record Yes
Weekend Record Record Info Yes
Average Normal PPS 3.75
Average Normal Quality Best
Follow these steps to Setup ezRecord:
* Select «How Many Days To Record» and press ENTER, then press
UP/DOWN to choose an option. The average normal PPS & Quality will be
adjusted automatically. The maximum of days depends of the size of your
HDD, in the other words, the larger the HDD installed, the more days the
unit can record.
* Move to «Daytime Record» and press ENTER. This item is for you to
Select whether you want the DVR to record during daytime. If so, use
UP/DOWN to select «Yes? as an option; or, select «No» for not recording
during daytime.
DVR-4TN/8TN/1GTN/16TS/18TT Series
SPECO TECHNOLOGIES 05/07