Speco DVR-4TN Manual page 81

User's Manual
NOTE: If the selected VGA resolution is too high for the monitor, the
message "No Signal" will be shown on screen. Then please press ESC
on the front panel to restore the original setting.
5.3 Camera Setup
The items in the Camera Setup menu enable the user to set camera
parameters, including camera title, dome protocol and ID for each connected
camera. The menu is shown below..
Camera Setup
1. Camera Select CH1
2. Dome Protocol None
3. Dome ID 0
4. Camera Title CH1
5. Covert No
6. Termination Yes
7. Brightness 0
8. Contrast 0
9, Saturation 0
10. Hue 0
11. Audio Association Both
Items in this menu are described in the following subsections.
5.3.1 Camera Select
This item is used to select a camera for setting parameters. The settings can
then be set for the related camera, such as dome protocol and camera title.
Move the cursor to «Camera Select» and press ENTER, then select a
channel using UP / DOWN keys.
5.3.2 Dome Protocol
Select the communications protocol associated with your dome camera using
the ENTER and Direction keys. The available protocol includes <DynaColor>,
«Pelco D>, «Pelco P», <AD422> : «Fastrax 2» and «None» (default).
5.3.3 Dome ID
This item is used to assign an ID number to the selected dome camera. Note
that ID number must match the ID address set by the dome.