Speco DVR-4TN Manual page 72

User's Manual
5.1.6.5
5.1.6.6
72
Connect
When the Dial-out related settings are configured, set this item to «YES» to
starting dial-out or select «NO» to disconnect.
Trigger Port
To avoid the possibility of the default service port (port 100)being blocked, this
Item enables the user to change port 100 into another port. To change the
trigger port, move the cursor over «Trigger Port» and press ENTER, then
adjust the setting by UP / DOWN keys. After you have entered a different port
and pressed ENTER, a message "Network restarting Please stand by" will be
shown on the screen. A message box will be displayed in approximately 30
seconds.
Port allocated...
ezRouter settin;
DDNS submitted.
WAN connection,
me
X
When the trigger port that you have just modified can be allocated, the 1? item
"Port Allocated" will be followed by a "O" symbol indicating that the designated
port is allocated. ^X" indicates that the port cannot be allocated. Note that the
DDNS port will be automatically changed to the same port as the trigger port.
For instance, when you have set the trigger to 123, the DDNS port will be
automatically changed to port 123. Therefore, when the ports are allocated,
"Port allowcated" and "DDNS submitted" will both be followed by the "O^
symbol. The 2"4 to 4" item will be discussed in «Network Restart» section.
Email Address
This item is used to edit the e-mail address where alarm event information will
be sent. Follow these steps to setup the e-mail address.
e Select «Email Address» from Network Setup menu and press ENTER. A
virtual keyboard displays.
e Use Direction keys to move the cursor for selecting character.
e Press ENTER to add the selected character to the password entry field.
e When done, move the cursor to «OK» and press ENTER to save the
settings and exit.
DVR-TN/8TN/IGTN/1GTSAGTT Serles
SPECO TECHNOLOGIES 05/07