Speco DVR-4TN Manual page 83

User's Manual
To set a camera to be covert, follow these steps:
a Select the channel that you want to be covert from the «Channel Select»
item.
» After selecting the channel, move the cursor to <Covert> item and select
<YES>.
5.3.6 Termination
This item is used to enable / disable the 75-termination resistor inside the
unit .that adjusts the image quality of each camera. <YES>= termination
resistor enabled (default), <NO> = termination resistor disabled.
NOTE: If the camera loop-out connectors have not been used, the
termination resistor should be enabled for appropriate signal
termination.
5.3.7 Brightness
Move the cursor to this item and press ENTER to adjust the brightness of the
camera. Use UP / DOWN keys to adjust the numeric value. The range of
brightness values is <-128> to «127». The default setting is «0».
5.3.8 Contrast
Move tho cursor to this item and press ENTER to adjust the contrast of the
camera. Use UP / DOWN keys to adjust the value.
5.3.9 Saturation
Move the cursor to this item and press ENTER to adjust the color saturation of
the camera using UP / DOWN keys. This value wil be ignored on
monochrome monitors. The range of saturation values is <-128> to «127».
The default setting is «07.
5.3.10 Hue
Move the cursor to this item and press ENTER to adjust the hue of the camera.
Use UP / DOWN keys to adjust the value.
DVR-ATNIBTNAAGTN/ 16TS/16TT Series
83
SPECO TECHNOLOGIES 05/07