Speco DVR-4TN Manual page 87

User's Manual
Per Camera Config
Cameral Select
CH1
Day Night Weekend
Normal PPS
75
7.5
7.5
Normal Qlty
Mid
Mid
Mid
Event Max PPS
30
30
30
Event Qlty
Best
Best
Best
Event Act
Both
Both
Both
5.44.1 Camera Select
This item is used to select a desired channel for setting the associated
parameters, Move the cursor to <Camera Select> and press ENTER, then
select a channel using UP / DOWN keys. Press ENTER again to confirm the
setting.
5.4.4. Normal PPS
Normal PPS (Picture per Second) is used to set the recording rate for normal
status.
Please note that the total normal pps for all channels is limited under the
maximum PPS for each Record mode. To increase one channel's pps, you
may have to reduce other's first. Event pps is not restricted to this rule, since a
smart event scheduler will handie the total pps automatically.
5.4.4.3 Normal Qity
This item is used to set the picture size for normal status recording. The
available options are listed as follow: «Low», «Fair», «Mid», «High» and
«Best».
5.4.4.4
Event Max PPS
Event Max PPS is used to set the event recording rate for Event status.
Normally, the Event PPS is set to be equal to or greater than Normal PPS; the
setting depends on your application. If the Event PPS is set to «0», the
DVR-4TN/8TN/16TN/16T8/16TT
series unit stops recording
event video
during alarms.
DVRATN/STN/16TN/ 16TSM6TT Series
87
SPECO TECHNOLOGIES 05/07