Speco DVR-4TN Manual page 58

User's Manual
5.1.5.2
5.1.5.3
5.1.6
58
Admin Password
Press Channel Keys To Enter Password
(4-8 Digits)
Press 4 To Delete
Use CHANNEL keys to input the new password and confirm the new
password. After setting the new password, press ENTER to save the settings
and exit.
Enable Password
This item ís used to determine if a password is required for accessing the
OSD menu. Select «YES? to demand entering password when accessing the
OSD menu; if not, select «NO».
Load Factory Password
'This item allows the administrator to reload the factory password incase the
administrator cannot remember the password. There are three options to
select from: «Admin» (reload the Admin password only), «User» (reload the
User password only), and «All» (reload the Admin and User passwords). The
factory password is 1234 for administrator and 4321 for user.
Network Setup
The Network Setup menu allows the administrator to configure the network by
specifylng the network related settings, such as IP address and Netmask, etc.
See your network administrator and/or network service provider for more
specific information.
Some settings under the Network Setup menu, such as IP and PPPoE
Account, need to be configured through the virtual keyboard. The function key
usage pattern is slightly modifled, please refer to Section 3.4.2 «Key Usage in
Virtual Keyboard».
From the System Setup menu, select «Network Setup» and press ENTER.
The following menu displays.
DVR-ATN/8TNHGTN/ATGTS/16TT Series
SPECO TECHNOLOGIES 05/07