Xerox ApeosPort C6550 I Network Administrator's Manual page 85

2) Select [TCP/IP - Get IP Address] and then select [Change Settings].
3) Select one from [DHCP], [BOOTP], [RARP], [DHCP/Autonet] or [Manual]. If you
select anything other than [Manual], proceed to step 4.
Note
4) Select [TCP/IP - IP Address] and select [Change Settings].
5) Select [TCP/IP - Get IP Address] and then select [Change Settings].
Note
6) Select [Save].
7) Configure [TCP/IP - Subnet Mask] and [TCP/IP - Gateway Address] as the above.
Note
4
Select [Close] repeatedly until the [System Settings] screen is displayed.
5
Select [Exit].
6
After the machine is restarted, print out a settings list to confirm that the ports are
enabled and TCP/IP is configured.
For information how to print a setting list, refer to "Print Report/List" in Chapter 12 of the User Guide.
Configuring E-mail Environment
The following describes the configuration procedure to use the e-mail feature.
Note
For information how to use CentreWare Internet Services, refer to "Using CentreWare Internet
Services" (P.53).
1
Display the [System Administrator Menu] screen.
1) Press the <Log In/Out> button.
2) Enter the UserID with the numeric keypad or a keyboard displayed by pressing
[Keyboard], and select [Confirm].
Note
3) Select [System Settings].
2
Set the E-mail address, host name, and domain name.
1) Select [System Settings].
2) Select [Network Settings].
3) Select [Machine E-mail Address/Host Name].
4) Select [E-mail Address] and then select [Change Settings].
5) Enter an E-mail address using the keyboard displayed.
6) Select [Save].
7) Set a host name and a domain name as above.
• When using a DHCP server, also configure the WINS (Windows Internet Name Service)
server.
• Enter address in the format "xxx.xxx.xxx.xxx". The "xxx" should be a numeric value in the
range from 0 to 255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.
• When you make an entry mistake, press the <C> (Clear) button and enter again.
• When moving to the next value without entering all 3 digits, select [save/select next].
• Enter address in the format "xxx.xxx.xxx.xxx". The "xxx" should be a numeric value in the
range from 0 to 255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.
• Specify the subnet mask by a combination of the numbers 0, 128, 192, 224, 240, 248, 252,
254, and 255. However, you cannot use 0 between non-zero values.
• If you do not set the gateway address, enter "0.0.0.0".
• The configuration can also be performed using CentreWare Internet Services or
CentreWare Utilities.
• The default UserID is "11111". When using the Authentication feature, a password is
required. The default password is "x-admin".
Installation Procedure
83
10